The Fast, Safe and Easy Way for One Person to Load or Unload Your
Motorcycle, Trike, Chopper, ATV, Snowmobile, Watercraft, Equipment etc.
Just 2 Easy Steps !
1 Roll a motorcycle up to the cradle and tie-down the front.
2 Press the button to load. (approx 30 seconds)
To Unload:
1 Press the Button and Pull back on the track to start the motion and let gravity and the controlled reverse action of the winch lower your bike to the ground.
(Lower Your Side Stand and Untie)
(See Photos @ Bottom of Page)
Loader in 6 1/2ft Puckup bed Loader in an RV Toter
Snowmobile Attachment
Trike Attachment
Handles BIG Motorcycles with ease (up to
1000lbs)
Fast and Simple One Person Operation
Lifts motorcycle from FLAT on the ground
Full lift cycle time under one minute
Strong Structural Steel 3 Piece Frame
ONE Person can set up and remove unit easily
2,500lb. Winch with safety brake
12' wired remote control (plug in)
Two units can fit in a standard width pickup bed
Fits almost any truck or trailer
Easy Installation with 3 bolts
Removes in just a few minutes
Tough Powder-Coat Finish for Durability
No trailer to park or store
No trailer insurance
No 55 MPH in slow lane
No trailer registration
No ramps or hitch
Specs:
The Standard lift is 95" long, and 24" wide. Front tire cradle is 6" wide and sits 7" above truck bed. A bar is attached with two bolts through the floor and bed frame at the front of the truck bed. For all pickups, 3 holes are drilled through the floor and bed frame. Route the all weather cable from this bar, to the truck's battery. The pre-assembled lift together with the winch motor is then slid into the truck bed and attached to the bar with two additional .5" bolts. Plug into the quick disconnect and you're ready to go. When in use, the tailgate must be removed on 8 foot beds and placed in the down position on shorter beds. Complete instructions are included with each lift.
2 Year Limited Warrantee
To Order: Just Hit the [Back] Button and Email or Call Us with your Request.
Visit Discount RV Marine (Page Host)